meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

outdoor_station:feature_guides:how_to_configure_multicast_in_r2x [2019/01/03 18:24] (current)
Line 1: Line 1:
 +\\  
 +====== How to configure multicast in R2X====== 
 +\\ <ff sans-serif><​fs medium>​Multicast uses one-to-many mode to communicate in a range. Akuvox products can be a listener part and also can be the listened part to realize multicast communication.</​fs></​ff>​ 
 +<note tip><​ff sans-serif><​fs medium>​R2X can only be used as a **listener** part.</​fs></​ff></​note>​ 
 +\\ <ff sans-serif><​fs medium>​Multicast IP address is from 224.0.0.0 to 239.255.255.255.</​fs></​ff>​ 
 +<note tip><​ff sans-serif><​fs medium>​Not all multicast IP addresses are valid. Please consult technical support for more information.</​fs></​ff></​note>​ 
 +\\ <ff sans-serif><​fs medium>​Go to **Phone - Multicast** to configure.\\ 
 +\\ 
 +**Paging Barge:** Choose how many multicast IP addresses need to listen, and the range is from 1 to 10.\\ 
 +\\  
 +**Paging priority Active:** Enable or disable the multicast feature. The call from high priority listened part can be answered preferentially. 
 +\\  
 +\\ {{ :​1.outdoor_station:​feature_guides:​outdoor_multicast_1.png?​nolink&​650* |Multicast}} 
 +\\ **Listening Address:** Enter multicast IP address which users need to listen. The multicast IP address need to be same as the listened part and the multicast port can not be same for each IP address.\\ 
 +\\ 
 + ​**Label:​** Enter the label for each listening address.</​fs></​ff>​ 
 +\\  
 +\\ {{ :​1.outdoor_station:​feature_guides:​outdoor_multicast_2.png?​nolink&​650* |Multicast}} 
 +<note tip><​ff sans-serif><​fs medium>​For listened part, please refer to [[7.ip_phone:​features_and_configurations:​how_to_setup_multicast|how_to_setup_multicast]].</​fs></​ff></​note>​