meta data for this page
This is an old revision of the document!
How to configure motion alarm in R2X
Go to Intercom - Motion to configure detection related parameters.
Motion Detection: To enable or disable motion detection.
Motion Delay: To configure minium time gap between two snapshots.
Motion Detect Time Setting: To make motion detect time for a whole week.
Action to execute: To choose which action to execute after triggering.
Http URL: To configure URL, if HTTP action is chosen.
SDMC Upload: Upload the capture snapshots to the SDMC.
Go to Intercom - Action to setup action receiver.
Sender’s email address: To configure email address of sender.
Receiver’s email address: To configure email address of receiver.
SMTP server address: To configure SMTP server address of sender.
SMTP user name: To configure user namer of SMTP service (Usually it is same with sender’s email address).
SMTP password: To configure password of SMTP service (Usually it is the same with the password of sender’s email).
Email subject: To configure subject of email.
Email content: To configure content of email.
Email Test: To test whether email notification is available.
FTP Server: To configure URL of FTP server.
FTP User Name: To configure user name of FTP server.
FTP Password: To configure password of FTP server.
FTP Test: To test whether FTP notification is available.
SIP Call Number: To configure sip call number.
SIP Call Name: To configure display name of R2X.