meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

ip_phone:features_and_configurations:how_to_setup_provide_code [2019/01/29 17:41] (current)
Line 1: Line 1:
 +====== How to setup provider code ======
 +===== Instruction =====
 +==== Feature Overview ====
 +<fs medium>​Dialing a special number in the keypad interface (special numbers need to both start and end with #), if the special number matches the parameter value in Autop pre-configured profile, then the phone system will enter Auto provisioning immediately .</​fs>​
 +
 +\\
 +
 +==== Feature Diagram ====
 +{{ :​7.ip_phone:​features_and_configurations:​provide_code.jpg?​nolink&​600 |}}
 +
 +
 +===== Configuration On Akuvox IP Phones =====
 +
 +==== IP Phone Auto Provisioning Provider Code Parameters on Akuvox IP Phones ====
 +^ Config.Autoprovision.X.Name = ^ Configure the name of Provider code.The range of the value X is 01~50 ^
 +| Config.Autoprovision.X.Code = | Configure the provider code for auto provisioning. |
 +| Config.Autoprovision.X.Url = | Configure the auto provisioning server. |
 +| Config.Autoprovision.X.User = | Configure Username of the auto provisioning server. |
 +| Config.Autoprovision.X.Password = | Configure Password of the auto provisioning server. |
 +| Config.Autoprovision.X.ComAes = | The AES for Common Configuration. |
 +| Config.Autoprovision.X.MacAes = | The AES for MAC Configuration. |
 +
 +
 +==== Autop Configuration ====
 +Autop function should be enabled before using Provider Code. 
 +Path: Upgrade->​Advanced->​Autop->​Mode->​Power On/​Repeatedly/​Power On+ Repeatedly ​
 +{{ :​7.ip_phone:​features_and_configurations:​autop.png?​nolink&​400 |}}
 +<​note>​Autop cannot be configured as Disabled, because Provider Code function needs to enter autop function immediately.</​note>​