meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

ip_phone:features_and_configurations:how_to_setup_call_completion [2019/01/18 15:47] (current)
Line 1: Line 1:
 +====== How to setup call completion ====== 
 +===== Introduction ===== 
 +<ff sans-serif><​fs medium>​Call Completion is a feature allows an alternative interaction between the parties that cannot communicate directly. When you dial a number but the called party is busy or unavailable to answer the call, the phone will show a prompt on screen to ask users whether to redial the number when the called party becomes available. \\ </​fs></​ff>​ 
 +<note important>​Call completion feature is only available on Akuvox v5.1 or higher firmware version and it requires PBX's support. </​note>​ 
 +===== Configuration ===== 
 +<ff sans-serif><​fs medium>​1.Call completion can be configured on phone LCD directly. Go to the Path **Menu - Features - Call Completion**. Enable Call Completion as below. Press **Save** key to apply the change. \\ </​fs></​ff>​ 
 +{{ :​7.ip_phone:​features_and_configurations:​call_completion_1.png?​nolink |}} \\  
 +<ff sans-serif><​fs medium>​2.After finishing the setting, when the called party is busy, the notification will be shown: \\ </​fs></​ff>​ 
 +{{ :​7.ip_phone:​features_and_configurations:​call_completion_2.png?​nolink |}} \\ <ff sans-serif><​fs medium>​3.Press **OK** to return to idle screen. \\ \\ </​fs></​ff>​ 
 +<ff sans-serif><​fs medium>​4.After the called party becomes available, the below prompt will pop up: \\ </​fs></​ff>​ 
 +{{ :​7.ip_phone:​features_and_configurations:​call_completion_3.png?​nolink |}} \\  
 +<ff sans-serif><​fs medium>​5.Press **OK** to redial the number. \\ </​fs></​ff>​