How to configure relay in linux indoor monitor

1.Relay setting

Users can press the Unlock key during the call.

.

1.1 Local relay


Go to Phone - Relay to setup the DTMF code of local relay in website.
Relay Type:There are two types of relay: chim bell and open door.

Chime Bell: When there is a call, the chim bell will ring.Open door: When press the unlock icon, local relay will be opened.

Relay Delay: To set the delay time for local relay.

Refer to Wiring Digram for chim bell and open door wiring.

1.1.1 Softkey in talking/idle page


Status: To enable or disable the softkey in talking page.

Display Name: To modify the display name of unlock icons in talking page.

Relay: To set the relay type, including local relay 1/2, remote relay HTTP and remote relay DTMF.

1.2 Remote relay

Please Users need to configure the same DTMF code in the door phone and indoor monitor.

Remote Relay: To set DTMF code for remote relay, which is “#” by default.

1.2.1 Remote relay via HTTP


IP/SIP: To configure he device IP or SIP account.

Remote Relay IP: To configure the device IP.(Note: Fill in the IP only if this device doesn't register a sip account.)

UserName/Password: The UserName/Password and password should be the same as the doorphone.

1.3 Webrelay

To configure the webrelay or the device’s information.
IP/SIP: To configure the device IP/SIP, which calling with IT83.

Web Relay Action: To configure the action text, you can check this command through the PCAP.