meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
6.multimedia_video_phone:features_and_configurations:how_to_setup_recording [2019/01/23 16:11]
inn
— (current)
Line 1: Line 1:
-====== How to setup call recording ====== 
-===== Introduction ===== 
-<fs medium><​ff sans-serif>​Call recording is used to record a call. It is supported by Sip server. Users can use Akuvox Phones,​including R47P、R47G、R48G、 to set Ext key as Record button which can be pressed during a call for recording. The recording will be stored in the server. Akuvox uses Elastix server as an example.</​ff></​fs>​ 
  
-===== Configuration on Video Phone ===== 
-<fs medium><​ff sans-serif>​Input the phone IP into the website. Type username and password(admin/​admin by default)to login.\\ 
-\\ 
-1.Go to the path: Phone->​Key/​Display;​Set a Ext key as Record,then click Submit</​ff></​fs>​ 
-{{ :​6.multimedia_video_phone:​features_and_configurations:​record1.png?​nolink |}} 
- 
-<ff sans-serif><​fs medium>​2. Register an Elastix account.</​fs></​ff> ​ 
- 
-===== Configuration on Sip server ===== 
-<ff sans-serif><​fs medium>​1.Go to the path: **PBX->​Basic->​General Settings** \\ 
-\\ 
-Set Dial command options and Outbound Dial command options as Ww. As shown below.Click Submit Changes,​then click Apply Configuration Changes Here.</​fs></​ff>​ 
-{{ :​6.multimedia_video_phone:​features_and_configurations:​record2.png?​nolink |}} 
- 
-<ff sans-serif><​fs medium>​2.Go to the path: **PBX->​Basic->​Feature Codes**\\ 
-\\ 
-Ensure the code(*1) of In-Call Asterisk Toggle Call Recording and enable it.\\ 
-\\ 
-Click Submit Changes,​then click Apply Configuration Changes Here.</​fs></​ff>​ 
-{{ :​6.multimedia_video_phone:​features_and_configurations:​record3.png?​nolink |}} 
- 
-<fs medium><​ff sans-serif>​3.Go to the path: **PBX->​Basic->​Extensions**. Choose the corresponding registered number.\\ 
-\\ 
-Set Record Incoming and Record Outgoing as On Demand.\\ 
-\\ 
-Click Submit,then click Apply Configuration Changes Here.</​ff></​fs>​ 
-{{ :​6.multimedia_video_phone:​features_and_configurations:​record.png?​nolink |}} 
- 
-<fs medium><​ff sans-serif>​4.Go to the path:​**PBX->​Monitoring** to check the recording.\\ 
-\\ 
-Users can listen or download the recording from the server.</​ff></​fs>​ 
-{{ :​6.multimedia_video_phone:​features_and_configurations:​record4.png?​nolink |}} 
- 
-<​note>​Please do not forget to click  "Apply Configuration Changes Here"</​note>​