meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
6.multimedia_video_phone:features_and_configurations:how_to_setup_provide_code [2019/01/29 17:31]
inn
— (current)
Line 1: Line 1:
-====== How to setup provider code ====== 
-===== Instruction ===== 
-==== Feature Overview ==== 
-<fs medium>​Dialing a special number in the keypad interface (special numbers need to both start and end with #), if the special number matches the parameter value in Autop pre-configured profile, then the phone system will enter Auto provisioning immediately .</​fs>​ 
- 
-\\ 
- 
-==== Feature Diagram ==== 
-{{ :​7.ip_phone:​features_and_configurations:​provide_code.jpg?​nolink&​600 |}} 
- 
- 
-===== Configuration On Akuvox IP Phones ===== 
- 
-==== IP Phone Auto Provisioning Provider Code Parameters on Akuvox IP Phones ==== 
-^ Config.Autoprovision.X.Name = ^ Configure the name of Provider code.The range of the value X is 01~50 ^ 
-| Config.Autoprovision.X.Code = | Configure the provider code for auto provisioning. | 
-| Config.Autoprovision.X.Url = | Configure the auto provisioning server. | 
-| Config.Autoprovision.X.User = | Configure Username of the auto provisioning server. | 
-| Config.Autoprovision.X.Password = | Configure Password of the auto provisioning server. | 
-| Config.Autoprovision.X.ComAes = | The AES for Common Configuration. | 
-| Config.Autoprovision.X.MacAes = | The AES for MAC Configuration. | 
- 
- 
-==== Autop Configuration ==== 
-Autop function should be enabled before using Provider Code.  
-Path: Upgrade->​Advanced->​Autop->​Mode->​Power On/​Repeatedly/​Power On+ Repeatedly ​ 
-{{ :​7.ip_phone:​features_and_configurations:​autop.png?​nolink&​400 |}} 
-<​note>​Autop cannot be configured as Disabled, because Provider Code function needs to enter autop function immediately.</​note>​