meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
4.cloud:how_to_add_devices [2019/01/29 16:50]
inn
— (current)
Line 1: Line 1:
-====== How to add devices ====== 
-<ff sans-serif><​fs medium> 
-To add a device to the SmartPlus, login SmartPlus first. Please refer to [[4.cloud:​how_to_login_smartplus|how to login smartplus]] to login. 
-Press “Add Device”, and then enter Device Code(Please refer to “How to get device code” at the bottom of the page.) and Location(It is used to distinguish the device from others) and press “Submit”.</​fs></​ff>​ \\  
- 
-{{:​4.cloud:​adddevice-1.png?​nolink&​400 |}}{{ :​4.cloud:​adddevice-2.png?​nolink&​400 |}} 
-\\ 
-<ff sans-serif><​fs medium> 
-The device is added successfully when there is such a po-up notification. Then, the device would be shown on the device interface.</​fs></​ff>​ \\  
- 
-{{:​4.cloud:​adddevice-3.png?​nolink&​400 |}}{{ :​4.cloud:​adddevice-4.png?​nolink&​400 |}} 
- 
-<ff sans-serif><​fs medium>​How to get device code ? 
-First, you need to power on all your devices, and connect them with the internet in a same router. 
-  * If you have get a indoor monitor (IT8x/C31x) 
-After the connection is finish, in next step, please choose’Cloud’,​ then you will see the page below.</​fs></​ff>​ \\  ​ 
- 
-{{ :​4.cloud:​adddevice-5.png?​nolink&​600 |}} 
- 
-<ff sans-serif><​fs medium>​In this page, we tell you how to download SmartPlus app. If you have already dowmload the SmartPlus, please click ‘next’ in right-top of the page. Then in next page, it will show you all device codes scanned by the indoor monitor (the indoor monitor will keep scaning in the same router).</​fs></​ff>​ \\  
- 
-{{ :​4.cloud:​adddevice-6.png?​nolink&​600 |}} 
-<ff sans-serif>​ 
-<fs medium>* If you don’t have any indoor monitor (IT8x/C31x) 
-With R29, you can see device code in page ‘Stauts’ of the setting mode. To swith to setting mode , you can first press 9999 in dial page, then press 3888.  
-With R27, you can see device code in page ‘System Information’ of the setting mode . To get in to the setting mode, you need to press ‘*2396#​’. ​     
-With other devices(R26\R20\E10),​ you need to press the call-putton for 5 seconds, then the microphone of the device will broadcast the device code.</​fs></​ff> ​ 
-