meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
2.indoor_monitor:feature_guides:how_to_enable_auto_answer [2019/01/29 16:12]
inn
— (current)
Line 1: Line 1:
-====== How to enable auto answer====== 
-<​note>​It will auto answer all incoming calls if it is enabled.</​note>​ 
-<fs medium><​ff sans-serif>​On the web portal, go to **Account** - **Advanced** to enable /disable auto answer feature.</​ff></​fs> ​ 
-<​note>​ Auto answer is only available with SIP accounts.</​note>​ 
-{{ :​2.indoor_monitor:​feature_guides:​auto_answer.png?​nolink&​400 |}} 
-<fs medium><​ff sans-serif>​On the web portal, go to **Phone** - **Call Feature** to setup auto answer whitelist. It will auto answer the incoming calls when the caller is in white list.</​ff></​fs> ​ 
-{{ :​2.indoor_monitor:​feature_guides:​auto_white_list.png?​nolink&​400 |}} 
-\\ <ff sans-serif><​fs medium>​**Device Location:** To enter the device name /​location.\\ 
-\\  
-**SIP/IP:** To enter the SIP /IP number of the corresponding devices.</​fs></​ff>​ 
-{{ :​2.indoor_monitor:​feature_guides:​whitelist.png?​nolink&​400 |}} 
-\\ <ff sans-serif><​fs medium>​**Auto Answer WhiteList:​** To display the SIP /IP number stored in IT83X’s white list.</​fs></​ff>​ 
-<note important>​White list takes effect both SIP account and IP address.</​note>​