meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
2.indoor_monitor:feature_guides:how_to_configure_monitor [2019/01/29 10:22]
inn
— (current)
Line 1: Line 1:
- 
-<​note>​Monitor feature enables users to view the real-time video from IP cameras or door phones anytime. </​note>​ 
- {{ :​2.indoor_monitor:​feature_guides:​monitor.png?​nolink&​400 |}} 
-===== How to check the monitor ===== 
-<fs medium><​ff sans-serif>​In the devie, choose the outdoor devices from the list. The real-time video from the door phone or IP camera will show in the screen .</​ff></​fs>​ 
- 
-{{:​2.indoor_monitor:​feature_guides:​monitor_detail.png?​nolink&​400|}} ​                                 {{:​2.indoor_monitor:​feature_guides:​live_view_video.png?​nolink&​400|}} 
-        
-<ff sans-serif><​fs medium>​Press the **Monitor** list in the right side to choose the outdoor videos.\\ 
-\\ 
-Press **List** button in the bottom right corner to wake the outdoor video list.\\ 
-\\ 
-Press **Unlock** to open the door which is connected with door phone.\\ 
-\\ 
-Press **Capture** to take a screen shot of current interface.\\ 
-\\ 
-Press **Cancel** to exit the monitoring.</​fs></​ff>​ 
-<note important>​ Only under Discovery mode, users need to press Update key manually to synchronous the devices which is in the same node.</​note>​ 
- 
-====== How to configure monitor ====== 
- 
-<​note>​There are two ways to configure: on device or on webpage</​note>​ 
-<fs medium><​ff sans-serif>​1. In the device, go to **More** - **Settings** - **More** - **Monitor**.</​ff></​fs>​\\ 
-{{ :​2.indoor_monitor:​feature_guides:​live_view_configure.png?​nolink&​400 |}} 
-<fs medium><​ff sans-serif>​**Number:​** To enter the IP address/SIP number of the corresponding camera. Enter the RTSP or ONVIF URL of the door phone or IP camera.\\ 
-\\  
-**Doorphone ID/Device Name:** To enter the ID number of doorphone, which could be set by users.\\ 
-\\  
-**RTSP Address/​Destination URL:** To set the RTSP URL for the door phone. The RTSP format of Akuvox door phone is</​ff></​fs> ​ 
-<​file>​ 
-**RTSP URL:** rtsp://​device IP/​live/​ch00_0. 
-</​file>​ 
-<ff sans-serif>​ 
-<fs medium>​**User Name:** To enter the user name if required.\\ 
-\\  
-**Password:​** To enter the password if required.\\ 
-\\ 
-2.On the web portal,go to **Phone** - **Monitor**,​ users can also setup the monitor information.(This configuration is the same as device, please refer to device configuration above.)</​fs></​ff>​ 
-{{ :​2.indoor_monitor:​feature_guides:​live_view_web.png?​nolink&​400 |}}